Vance and Hines FuelPak3

Q: My question is about the Vance and Hines FuelPak3. I own a few bikes, but my question is does the FULPAK3 work on a 2013 CVO Breakout? I have spoken to more than one HD shop and they said it would. I have also seen on websites maps and installs on 2012’s and 2014’s but nothing on a 2013 CVO. I went even further and spoke with a Vance and Hines rep. He stated that the reason they say it doesn’t fit the 2013’s is because they did not test it on a CVO in their factory etc. The final unexplained question, what is different from a 2012, 2013 & 2014 CVO except the slipper clutch and paint? Will it work, the FP3 on a 2013 CVO 110?

A:Vance & Hines FuelPak will work with your 2013 CVO. If you have any problems bringing up the correct map for your m/c, they direct you to a map request form. You may not get your map until the next day, but it will be worth the wait. The FuelPak is easy to use and works flawlessly.

Q: I have a 2014 Softail slim with a 103b motor. I had V and H short shots installed along with a screaming eagle air filter and they ran it through the Dyno for the Stage 1 upgrade. My question – is there any benefit to getting a Vance and Hines fuel pak 3 to install? The engine pops some on deceleration and I am thinking that might not be great for it. Would the fuel pak give me better performance than the setting done by the dealer?

A: You may have better luck with the V&H Fuel Pak. It has advanced deceleration modes for smoother operation. May reduce, or eliminate decel popping.

Related Videos:
Vance and Hines Fuel Pak 3 Install

Vance and Hines FuelPak review
  • (will not be published)

No Comments