With the new gasket already installed in the front and rear cylinders on your Softail model, Bob and Mark demonstrate the process for installing a 2:1 performance exhaust. They stress the importance of working with care so that you don’t scratch the surface of the pipe.
Bob and Mark put an older Sportster up on the lift to show you how to service the front and rear brake calipers. They teach you which parts to remove, clean and replace, and discuss the components of the single piston-style caliper assembly and how they work.Watch Now >>
Bob teaches you how to service the spark plugs on your Harley’s engine. Although you can clean and service your old spark plugs, Bob recommends just buying new ones because they are fairly inexpensive. You should purchase gapped, Harley-only spark plugs which usually come with a gap of 38-43,000th of an inch. After applying some anti-seize to the threads of the new plugs, you can thread them into the cylinder by hand and tighten them with a torque wrench and you’ll be good to go.Watch Now >>
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>
Harley tools are not only specialty tools like JIMS and Kent Moore but many that you have in your garage already. Bob LaRosa gives us a great overview on some of the basic tools we need to service our Harley-Davidson from oil-change to custom part install. Bob shows us that tools are only part of…Watch Now >>