Bob and Mark demonstrate the installation process for the custom Headwinds and Dakota Digital products that you have wired and prepped for your Softail model. These are your headlights, passing lamps and dashboard gauges. This is your last chance to make sure all wires are properly wrapped, attached and secured! Your bike should look drastically different from what you had before your custom servicing. Now get out and take a test drive!
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>
Harley tools are not only specialty tools like JIMS and Kent Moore but many that you have in your garage already. Bob LaRosa gives us a great overview on some of the basic tools we need to service our Harley-Davidson from oil-change to custom part install. Bob shows us that tools are only part of…Watch Now >>
Bob teaches you how to adjust the clutch and primary chain on your Harley Softail or Dyna model. Be sure to achieve free play on the clutch cable to verify that you have proper adjustment on the clutch cable pack, and check for the proper specs in your service manual for adjusting the primary chain (if your model has the adjustment window). Bob finishes by mentioning that when you are doing this type of repair, only factory service gaskets should be used.Watch Now >>