Bob reviews the throttle by wire on the Twin Cam 96 and 103 and how to install an aftermarket air cleaner. He even points out the factory warning on the throttle body box.
Bob and Mark demonstrate the best way to remove and replace the rear tire on your Harley Sportster. Then Bob shows you how to service the rear axle and inspect the wheel bearings so you can guarantee a smooth and safe ride. Also, he makes sure to apply anti-seize on the axle.Watch Now >>
Bob and Mark teach you how to properly service important parts on your bike, including draining and replenishing the fluids, adjusting the clutch and the primary chain, inspecting the clutch cable and servicing the kickstand. They pinpoint a few problems to look for when servicing each of the parts, and give you some tips on how to deal with any of these possible problems. They also stress the importance of paying particular attention when removing and re-installing parts.Watch Now >>
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.Watch Now >>