Upgrade to GOLD membership and get unlimited access to our entire library of premium Harley repair videos, receive discounts on DVDs, video downloads, and classes in the shop. In addition, you’ll receive sixteen video downloads, access to GOLD member LIVE events, and so much more!
When you’re adjusting the primary chain on your Sportster model, it’s always specified to adjust it in the tightest spot of its travel. Whether you use the hot or the cold measurement, Harley specifies that you do it in the tightest area. Bob teaches you a quick and simple method for locating the tightest spot in the path of the chain. He stresses that any time you are servicing inside the primary you should always unhook the negative cable.
Bob bleeds for us. Well, he bleeds the front brakes on this custom caliper set up. He notes the two bleeder set up and that we should remove old fluid before replacing with new. Check your manual DOT4 and DOT5 do not mix. They go pro with the use of a Brake Bleeder that pushes…
Bob teaches you how to service the spark plugs on your Harley’s engine. Although you can clean and service your old spark plugs, Bob recommends just buying new ones because they are fairly inexpensive. You should purchase gapped, Harley-only spark plugs which usually come with a gap of 38-43,000th of an inch. After applying some anti-seize to the threads of the new plugs, you can thread them into the cylinder by hand and tighten them with a torque wrench and you’ll be good to go.
Now that you’ve fully serviced your Harley Sportster, you can take the opportunity to check all of the safety features on the bike. Make sure the lights are working properly, the horn makes noise, turn signals are operational, and all grommets are in place. Then you should check the throttle, add oil and fill the tires to the correct level. Once your finished with the service, get out and ride!
*****The service manual states you should follow your negation cable down from battery and remove nut that secures the connector to ground stud on the crankcase boss behind the starter motor assembly. You will need to do the reverse during installation.