Bob discusses the components of the Evolution Stator and Regulator Rectifier charging system for Sportster model years 1999 and older. He talks about what each part does, shows how they fit together and points out things that you should look for if the system isn’t working correctly.
Bob and Mark teach you how to properly service important parts on your bike, including draining and replenishing the fluids, adjusting the clutch and the primary chain, inspecting the clutch cable and servicing the kickstand. They pinpoint a few problems to look for when servicing each of the parts, and give you some tips on how to deal with any of these possible problems. They also stress the importance of paying particular attention when removing and re-installing parts.Watch Now >>
In this quick demonstration of the Harley Sportster battery removal, you’ll learn how to remove your bike’s seat and side cover so you can check on the condition of your battery and its operating components. It is strongly recommended that you remove the negative cable of the battery first and replace it last when servicing your bike. If you remove the positive cable first, you risk causing a dangerous spark if the battery comes in contact with your bike’s frame. Bob has been dealing with these batteries for years and removes the neg from the battery. If this is your first time, we highly suggest removing neg from ground stud on the crankcase boss(see images)with wobble extension.Watch Now >>
Harley tools are not only specialty tools like JIMS and Kent Moore but many that you have in your garage already. Bob LaRosa gives us a great overview on some of the basic tools we need to service our Harley-Davidson from oil-change to custom part install. Bob shows us that tools are only part of…Watch Now >>
When you’re adjusting the primary chain on your Sportster model, it’s always specified to adjust it in the tightest spot of its travel. Whether you use the hot or the cold measurement, Harley specifies that you do it in the tightest area. Bob teaches you a quick and simple method for locating the tightest spot in the path of the chain. He stresses that any time you are servicing inside the primary you should always unhook the negative cable.Watch Now >>