• Harley Throw Out Bearing
    39:21

    Harley Throw Out Bearing

    On the right side of your Harley, behind the transmission side cover (aka clutch end cover) you will find the transmission door bearings. These two bearings are critical as they support the heavy load at the end of the transmission main and and counter shafts. Failure It is not uncommon for these bearings to eventually…

    Watch Now >>
  • Jims Transmission Fat 5 Overview
    9:11

    Jims Transmission Fat 5 Overview

    Bob LaRosa introduces us to another Fix My Hog Video Class. We will be installing a Jims transmission. During the video we will show a Jims Fat 5 Overdrove install. No matter if you are servicing your transmission or doing an upgrade this class reviews the step by step process of removing the transmission and…

    Watch Now >>
  • Harley Rear Tire, Drive Pulley and Inner Race Removal
    9:46

    Harley Rear Tire, Drive Pulley and Inner Race Removal

    To start this project and save some time we removed the exhaust and primary drive. If you are not familiar with those procedures, please review the related video links. Bob starts the transmission project by removing the Harley rear tire, drive pulley and inner race. Next Video in Class: Harley Shifter Fork Removal Related Videos:…

    Watch Now >>
  • Harley Shifter Fork Removal
    16:51

    Harley Shifter Fork Removal

    The next step for this project will be to remove the Harley clutch cable, transmission top cover, shifter drum and shifter fork. You will not be reusing some of them but you should clean them, mark them and note bolt locations. Maybe take a few pics along the way. Make sure to tape off any…

    Watch Now >>
  • Harley Transmission Removal
    11:18

    Harley Transmission Removal

    This video how-to class focuses on Harley transmission removal. We have to remove the electronic speedo sensor, clean it, inspect it, wrap it and set it aside. We remove the hardware on the transmission trap door by loosening the small bolts first. We use a specialty tool to pull the trap door, the shafts and…

    Watch Now >>
  • Harley 5 Speed Transmission Main Drive Gear Removal
    9:30

    Harley 5 Speed Transmission Main Drive Gear Removal

    We are at a point with this Harley 5 speed transmission removal that we need to remove the main drive gear. We’ll remove the seal from the case, wipe it clean and set it aside. You will need to remove the quad seal to use the specialty tool to remove the main drive gear. Next…

    Watch Now >>
  • Harley Counter Shaft Bearing Removal
    10:50

    Harley Counter Shaft Bearing Removal

    This video shows how to remove the Harley main drive gear bearing and counter shaft bearing. Take your time and wear safety glasses when removing the retaining clips. Clean up as you go and use the right tools for this job. Next Video in Class: Harley Countershaft and Main Drive Bearing Install Other videos in…

    Watch Now >>
  • Harley Countershaft and Main Drive Bearing Install
    12:52

    Harley Countershaft and Main Drive Bearing Install

    This video shows Harley countershaft bearing installation. Use a new bearing and follow these steps. Once done you can install the main drive gear bearing. Follow along with Bob and these steps to make sure the job is done correctly. A very important note. If you are installing a JIMS Fat 5, it is best…

    Watch Now >>
  • JIMS Transmission Main Drive Gear Install
    14:23

    JIMS Transmission Main Drive Gear Install

    This video shows how to install the JIMS transmission main drive gear. You will need a specialty tool and a second set of hands will come in handy. Follow along with Bob and these steps to make sure the job is done correctly. A very important note. If you are installing a JIMS Fat 5,…

    Watch Now >>