• 11:29

    Sealed Harley Wheel Bearings Replacement

    Harley Wheel Bearings: Was Old Better? Up until 1999, the motor company used conventional, serviceable Harley wheel bearings. These were high quality bearings made by Timken. They were packed with grease and set against a bearing race with a wheel bearing seal on the outside end of the wheel hub to block out the elements…

    Watch Now >>
  • Harley-Davidson wheel bearings
    48:54

    Harley-Davidson® Wheel Bearings Replacement

    Sealed wheel bearings are supposed to make things easier for us. Now we do not have to pack grease into the bearings like before and this saves us a maintenance step. Here’s the rub, the axle can start to seize to the bearings or the bearing can start to seize to the hub. Bob shows…

    Watch Now >>
  • Fork Seal Leak
    14:56

    Harley Fork Seal Leak Fix

    You may develop a Harley fork seal leak at some point. It’s a rubber seal and they were out and deteriorate over time. Another Vice Mike shows us how not to pick up another vice. He uses the motorcycle as the vice to remove the tubes. Make sure everything is clean and free of debris.…

    Watch Now >>
  • Harley Valve Replacement
    7:21

    Harley Fuel Valve Replacement

    I Still Have a Carburetor! Every carbureted Harley Davidson has a Harley fuel valve or aftermarket one. This valve allows the rider to control the on/off delivery of fuel to the carburetor. The fuel valve also has a reserve position that helps the rider to monitor fuel quantity, and can be used as a fail…

    Watch Now >>
  • Motorcycle Compression Test
    6:40

    Harley Motorcycle Compression Test

    Know Before You Invest In this video, Bob takes us through a compression test on a Twin Cam motor. The motorcycle in this video has sustained damage due to an accident. It is already known that the frame will need to be replaced. It is, also, important to know the status of the motor before…

    Watch Now >>
  • Harley Fuel Pressure Tester
    7:10

    Using a Harley Fuel Pressure Tester

    Poor fuel economy, hesitation, cutting out, and no start are all symptoms of improper fuel pressure. In this video, Mike walks us through the use of a Harley Davidson fuel pressure tester gauge to identify the fuel pressure on your Harley motorcycle. There are a handful of reasons that an injected fuel system may have…

    Watch Now >>
  • Harley Davidson Master Cylinder Rebuild (Rear)
    19:50

    Harley-Davidson® Master Cylinder Rebuild (Rear)

    Bob LaRosa shows us the step-by-step process on rebuilding the rear Harley-Davidson® master cylinder. Why would this need to be done? The metal inside the cylinder can start to breakdown and/or the component may start to leak. You may notice that even after bleeding your brakes you still get a spongy lever. This procedure can…

    Watch Now >>
  • Harley Master Cylinder – Rebuild
    22:54

    Harley Master Cylinder – Rebuild

    This video shows you how to rebuild a Harley master cylinder. Bob LaRosa works on the 9/16 bore front master cylinder. Get started by removing the cover and any residual fluid or debris. Take everything apart and compare the old to the new parts to make sure you have everything that you need. Related Videos:…

    Watch Now >>
  • Harley 4 Piston Caliper Rebuild
    47:15

    4 Piston Front Caliper

    This video covers rebuilding a Harley four-piston caliper. It is very important to have all your tools and new parts on hand. Compare the old parts with the new to make sure you have every thing you need. Take your time and work clean. Related Videos: Twin Cam: Rear Brake Pads and Calipers Rear Caliper…

    Watch Now >>